Understanding The Installation Of A Shower Faucet

A leaky bathroom shower faucet is annoying, wasteful and leads to higher water bills. It usually occurs from a damaged part in the faucet, often the washer on the shower stem.

It is a good thought out plan to move for a full replacement of all the gaskets and seals when you decide to do a shower faucet refurbishment. In case you are doing for the first time in refurbishing a specific faucet, it might happen that you have to look for the accurate types and amount of washers and seals you need. But it is always advisable to straightly go to a hardware shop where the expert person can help you in getting your essential parts.

Drips in your shower faucet not only profligate water, it also expands your water bill. Mentioning the difficulty and mending it as early as possible is intelligent and eco-friendly.

A drippy shower faucet is basically a symptom that a section is dog-eared and requires replacement. The washers and seals undergo pressure as water runs into it and hence it is normal that they dog-eared over the time.

Turn off the water heater in your house that is generally situated in the basement or garage. If a gas water heater is being used, then you will only have two hours to finish mending else there will be damage to the tank. Come again to your faucet and switch it on to free if there is any water stored up.

In case you have a two-knob system, then you will have to take out and reinstate both the valves. So, at first loosen the valves and take out the knobs and handles.

Carefully remove the guard and set it aside. There will be two nuts, only one of which needs to be unscrewed in order to reach the shower stem. Unscrew the larger of the two nuts and leave the packing nut alone. To remove the shower stem, unscrew in a counterclockwise direction. Keep track of how the shower stem is assembled.

Before putting the shower stem back, take the opportunity to clean any junk from the pipes. Put the shower stem back into the pipe in reverse order from how you took it out. In order to prevent damage, re-caulk the faucet plate. When completely finished, don’t forget to turn your water heater back on.

Scott Rodgers is a well known writer who has been giving huge guidance on plumbing works all over the country. His splendid knowledge has, in fact, sparked significant rise in revenue for talented plumbers across the nation, from New York Plumbers to Denver Plumbers.

Share and Enjoy:
  • Digg
  • del.icio.us
  • Facebook
  • NewsVine
  • Reddit
  • StumbleUpon
  • Google Bookmarks
  • Yahoo! Buzz
  • Live
  • LinkedIn
  • MySpace
  • MisterWong
  • Twitter

One Response to “Understanding The Installation Of A Shower Faucet”

  1. shower faucet says:

    I had to replace one of these once but ran into a big problem.
    The cartridge was actually stuck inside the housing. The contractor that installed the original plumbing got a little too frisky with the torch and melted the plastic inside the housing.
    It took a LOT of careful prying and pulling to get that cartridge out.
    It made a 15 minute job into about a 3 hour one.

Leave a Reply

Security Code: